Zfiber not excitation when Zfiber strength is changed

mob

Hi, When I change the zfiber strength on muscle, the excitation donot occur.
When the strength exponential is at 10³ the excitation of muscle works normally but when I change the excitation exponential to 10⁵ or any other, I donot see the excitation.
The excitation is done through LOA. When I use keyframe for excitation at higher excitation exp it works but not with LOA.

Essex

mob When the muscle strength is larger, less excitation is required to achieve the same amount of contraction. The LOA code understands this, so when you make the muscle 100 times stronger, it excites the muscle 1/100 times as much. You can adjust this by changing zLineOfAction.posSensitivity. Setting that to 100, makes it excite the fiber 100x as much, so you should get about the same amount of excitation you were getting before you increased the zFiber strengthExp.