I tried to use mrlnk as a basis for learning, but I am still a novice, and I am not sure what happened in the middle of the process, which caused the collapse of the fat simulation process
This is my fat test post effect, Youtube path
↓↓↓↓↓
Question
I tried modifying reduce the amount of pressure on your inner material attribute, and also simulating full timeline animation
fat_underarms_material Pressure changed from -3000 to -1500
fat_interior_material Pressure changed from -2000 to -1000
But obviously, in the middle of the process, there will still be a few frames that will collapse
Is there a way to remedy this~